![]() The Network you are trying to extend is security enabled, you will be Step 5: The range extender will now scan for available wireless networks. Step 4: Select the option Extend an Existing Wireless Network or Wi-Fi Select your desired Language and click Next SITE YOU WILL NOT HAVE INTERNET ACCESS DURING THE SETUP PROCESS YOU MUST BE CONNECTED TO THE RANGE EXTENDER WIFI SIGNAL TO ACCESS THE ABOVE Note: If you cannot access it using, try Step 3: Open a Web browser and go to: or You should be directed to the range extender configuration page and the Install Wizard will appear (Located on the Configuration note supplied with the range extender and on the bottom of the range extender) example: Dlink-68BE. Step 2:From a wireless computer/device, scan for available networks and connect to the pre-defined SSID Note: The light should turn red and then start blinking orange The Wifi password will be the same as the network you are extending. On your wireless device and connect to the Wi-Fi Network Name which looks like your wifi signal with the -EXT added to the end of it. Starting point is approx half way between the router and the area youĬonnect wireless to the range extender, Scan for available wireless networks In an area that still receives good signal from your router. Placement of the range extender is very important. Note: If after moving your Range Extender, the signal strength indicator is showing one single amber bar or if your Range extender LED does not turn solid green within 3 minutes, move your Range Extender to a wall outlet closer to your wireless router/AP. You can now unplug an move your Range Extender to a location between your wireless router/AP and the area where you want wireless coverage. ![]() Step 4: When the status LED is solid green, this indicates the Range Extender is securely connected to your wireless router/AP. Once it makes connection with your router the LED Step 3: Once confirmed the WPS/Wi-Fi light is blinking on your router, within one minute pressĪnd hold the WPS button on the DAP-XXXX, range extender for 2-3 seconds. NOTE: If the WPS or Wi-Fi LED is not flashing, Configure your Range Extender with the QRS Mobile Setup. Try holding the WPS on the router a little longer. NOTE: The WPS LED or the Wi-Fi LED on your router should start to flash, if it doesn't flash the WPS feature on the router may be turned off. Step 2: Press the WPS (Wi-Fi Protected Setup) button on your wireless router/AP for 3 seconds. ![]() Note: You can move it to a more suitable location, after it is set up Wait until the status LED is blinking amber. Step 1: Plug in the range extender, near your wireless router/AP. ![]() New Extended Signal- Home Network -EXT (wifi password - 123456789) Home Wifi Network- Home Network (wifi password - 123456789) Same wireless password as the signal you are extending. It will add the -EXT extension and use the Note: When configuring the range extender using WPS, it willĬreate a NEW network name for the extended signal similar to the Note: In order to setup the range extender using WPS, you must have a WPS compatible router/access point Please select your version and desired configuration method: The steps will be similar with our other range extenders. NOTE: This example shows setup process of DAP-1620. How do I setup and install my WiFi range extender?
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |